Garage Door Services
Eight jobs, grouped by what the door is actually doing right now
Free estimate, seven days
It will not close, or it closes crooked
Counterbalance or guide path. Scheduled first, because it strands cars.
Spring repair and replacement
Wire size, diameter and length matched to the door as built, tension set by turn count.
Call about thisOff-track and misaligned door correction
Track straightened or replaced, runs checked for level and plumb, and the cause fixed, not just the symptom.
Call about this
It runs, but it sounds wrong
Noise is early warning.
Cable, roller and track repair
Cables replaced in pairs so the drums stay in phase, sealed-bearing rollers, dented sections dressed or swapped.
Call about thisAnnual maintenance and tune-up
Balance corrected, bearings lubricated, fasteners torqued, cables inspected, safety reverse tested.
Call about this
The opener will not listen
Electronics separated from mechanics first.
Opener repair and installation
Door worked by hand first, then a real diagnosis: board, gear, travel and force settings, sensors, remotes.
Call about this
The door itself is damaged or dated
Structure, not mechanism.
Panel replacement
Single sections swapped where the model is available and the neighbours are sound.
Call about thisNew residential door installation
Opening measured, clearances confirmed, track and spring specified to finished weight, seal set to the real floor.
Call about this
It is a bay door, and downtime costs money
Different duty cycle.
Commercial and roll-up doors
Shutters, counterbalance rebuilds, drum and shaft work, jackshaft operators, safety edges and photo-eyes.
Call about this
THE REPAIR HOLDS
MEASURED, FITTED AND CYCLE-TESTED ACROSS NAPLES AND COLLIER COUNTY
Questions worth asking
How do I know whether the spring is the problem?
Pull the release cord, lift the door halfway by hand and let go. A balanced door stays put. If it drops the spring is tired; if it rises it is over-wound.
Why does my door reverse before it touches the floor?
Usually the photo-eyes are misaligned or dirty, or the close force is set too tight. Both are adjustments rather than replacements.
Can one damaged panel be replaced on its own?
Often, if the model is still made and the sections either side are square and sound. Where no match exists we say so.
What makes a door suddenly loud?
Flattened roller bearings, loose hinge fasteners, or a dented track section — wear you can still get ahead of.
Talk to someone who does the work
Free estimate, seven days a week, 7:00 AM to 7:00 PM. Tell us what the door is doing and we will tell you what it needs before anything is ordered.